بیتوسیل® انامل
مرداد ۱۱, ۱۳۹۵
نوار رویی بیتوسیل®
مرداد ۱۲, ۱۳۹۵
Show all

Download PDF version here.

Product Data Sheet

Product Name:
BITUMEN® ENAMEL
Standard:
EN 10300 Category 1, Grade b and c / AWWA C 203

Product Description

The Bitumen Enamel is based on specially selected bitumen which is modified by oxidation.

Delivery

Bitumen Enamel is available cold in 20 kg block or hot in bulk.

Application

Bitumen Enamel is applied to steel pipes, previously primed with Synthetic Primer, at 215-230°C. Also one layer of inner-wrap and one layer of outer-wrap are used in this coating system.

Storage

Heated Bitumen Enamel is to be stored under constant low-speed stirring. Storage temperature and duration depends on the Bitumen grade stored.

Standards

The Bitumen Enamel meets or exceeds all the performance requirements of  EN 10300 Category 1, Grade b or c and AWWA C 203.

Quality Control

All raw materials for Bitumen Enamel are tested and approved in the laboratories of Varziran. The quality of the finished enamel is controlled to either EN 10300 or the costumer’s specific requirements and a quality certificate is issued for each batch produced.

BITUMEN® ENAMEL Type 1 Grade b
Technical Data
PropertiesUnitRequirementMethod of test
Softening PointºC110 to 130EN 1427
Penetration0.1 mm5 to 17EN 1426
Density at 25 ºCg/cm31.2 to 1.4EN 10300, Annex L
Filler Content%25 to 35EN 10300, Annex K
Flash PointºCMin 260EN/ISO 2592
Sag at  75 ºC , 24 hºCMax 1.5EN 10300, Annex D
Impact disbonded area @25ºCmm2Max 6500EN 10300, Annex E
Peel Initial / Delayed at

30  ºC

40  ºC

50  ºC

60  ºC

 mm3

3

3

3

EN 10300, Annex F, F.4.1
Bend at 0ºCºCMin 15EN 10300, Annex G
Cathodic Disbonding, Disbonded radius after 28 daymmMax 10EN 10300, Annex I

 

BITUMEN® ENAMEL Type 1 Grade c
Technical Data
PropertiesUnitRequirementMethod of test
Softening PointºC120 to 150EN 1427
Penetration0.1 mm5 to 15EN 1426
Density at 25 ºCg/cm31.4 to 1.65EN 10300, Annex L
Filler Content%45 to 55EN 10300, Annex K
Flash PointºCMin 260EN/ISO 2592
Sag at  75 ºC , 24 hºCMax 1.5EN 10300, Annex D
Impact disbonded area @25ºCmm2Max 6500EN 10300, Annex E
Peel Initial / Delayed at

40  ºC

50  ºC

60  ºC

 mm3

3

3

EN 10300, Annex F, F.4.1
Bend at 0ºCºCMin 10EN 10300, Annex G
Cathodic Disbonding, Disbonded radius after 28 daymmMax 10EN 10300, Annex I